Megatune files to megasquirt4/1/2024 ![]() Be sure you load it with the MicroSquirt version of the firmware. Specify that you are upgrading from standard B&G firmware.Ĭaution: Loading the MS2/Extra version for a full sized MegaSquirt will cause problems with the ignition output, and may even damage your ignition system. This program will first ask you a couple of questions about loading the code tell it you have a MicroSquirt and which COM port you are using. Open the program called download-MS2-firmware.bat. If MegaTune or other tuning software is running, close it. Go into the Program Files/MegaSquirt folder and open the MS2/Extra folder that matches the firmware you wish to load to your DIYPNP. If loading the code on the car, be sure to unplug the coils and injectors. ![]() This can be done on a car or you can plug our Stimulator / DIYPNP power supply into the supplied 12 volt port next to the DB15. ![]() Place the boot jumper (located to the right of the INPUT 1 label and above the IGN1 - IGN2 - WLED - ALED jumper) across both pins.Ĭonnect the DIYPNP to your computer using the serial port. So I've built and jumpered the diypnp to my 2001 miata, and im following these install instructions. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |